消防管道鍍鋅管外徑160破裂漏水不銹鋼全環(huán)繞抱箍修補器快速型

地下室、停車場的消防鍍鋅管道如果發(fā)生砂眼滴水讓出人的人頭疼，這時，如果換管子，工程量浩大，因此采用不銹鋼抱箍可以進行快速修補！

上海元冬抱箍安裝說明書

                             Installation Instructions

Step 1

Thoroughly clean the pipe where the clamp will be installed.

將要安裝抱箍的管道清理干凈。

Step 2

If conditions permit, place a reference mark on the pipe a measured distance from the center of the break or damaged area.

如果條件允許，在管道破裂處或受損范圍中間做個記號。

Step 3

Place the clamp around the pipe, centered over the break or damaged area, with the gasket flap at the top.

墊圈朝上，用抱箍包住管道破裂處或者受損范圍的中間。

Step 4

Tuck the gasket flap in place and mesh the lug fingers. Engage the centermost bolt（s） in the drop lugs and tighten finger tight.

卷起墊圈，使套管相互嚙合，把zui中間的那根螺栓插入套管中并鎖緊。

（Note: The clamp may be assembled beside the break or damaged area and slid into position, if the pipe surface is wet or has been lubricated.）

（注：如果管道表面是濕的或者被注了潤滑油，抱箍可能安裝在破裂或者受損處的周邊滑動）

Step 5

Rotate the clamp to insure proper seating of the gasket, and position the bolts and nuts for convenient tightening.

旋轉抱箍到合適位置確保墊圈位置的準確并調整好螺栓和螺母的位置，方便擰緊。

Step 6

Tighten the bolts working from the center outward. Compley tightening the center bolt will usually stop or sufficiently retard the leakage to simplify completion of the installation.

由中心向外鎖緊螺栓，*擰緊中間的螺栓通常就能夠阻止或者有效地延緩泄露。

Step 7

When bolts have been tightened sufficiently to stop the leakage, measure from the reference mark （Instruction 2） to the center of the clamp to see if the clamp is properly positioned over the break or damaged area. Loosen the bolts and reposition the clamp if necessary.

在鎖緊螺栓防止泄露之后，測量做記號處到抱箍的中心，檢查抱箍是否準確安裝在破裂或受損區(qū)域。若有必要，可以松開螺栓重新安裝夾鉗。

Step 8

Recheck the tightness, and torque the bolts as evenly as possible.

重新檢查抱箍是否安裝牢固并盡可能用扳手均衡地扭矩螺栓。